Cdm9з”µжњєзљ„зј–зё‹пј€vlпј‰.mov -

Locate the SW1 switch (typically next to the red LED) and turn it ON .

If the unit remains unresponsive after power checks, the power or processor cards may require replacement. 5. Maintenance Intervals

Press the "Arrow Down" button. The door should drive down to the floor, automatically reverse to the upper buffers, and stop. CDM9з”µжњєзљ„зј–зЁ‹пј€VLпј‰.mov

Verify the connection block X1:7 (low voltage neutral) and ensure nominal voltage is within ±10%.

Recommended every 20,000 cycles or 365 days , whichever comes first. Product datasheet - ASSA ABLOY ENTRANCE SYSTEMS Locate the SW1 switch (typically next to the

Before initiating the "programming the road" sequence, ensure:

If the motor fails to respond or program correctly, refer to these common issues identified in service tool manuals : Maintenance Intervals Press the "Arrow Down" button

If the door uses a pneumatic seal (bottom gasket), ensure a solid floor surface is available; without a floor or obstruction, the machine cannot calibrate the stop position. 3. Programming Procedure ("Programming the Road")