Delta - 52 611 Sander Manual

Insert the support rod into the base and tighten the socket head screw.

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation Delta 52 611 Sander Manual

Slide the table assembly onto the rod and secure it with the secondary socket head screw. Insert the support rod into the base and

: Overall height of 60", weighing roughly 200 lbs. Setup and Installation Slide the table assembly onto

: Tilts 45° out (away from belt) and 20° in (toward belt).

Maintain a minimum clearance of between the table and the sanding belt for safety.

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine