How To Setup And Use A Laser Cutter With Rd Works ❲100% Tested❳

Before connecting your hardware, you must install the software and its drivers correctly.

In RDWorks, go to the bottom right settings panel and click "Test." If it says "Port test success," you are ready. 3. Basic Operations in RDWorks How to setup and use a laser cutter with RD Works

In the setup window, select your language and preferred unit of measurement (mm or inches). 2. Connecting the Machine Before connecting your hardware, you must install the

Use the cable provided and plug it into the port labeled "PC" on the machine (avoid using the port for USB flash drives). Basic Operations in RDWorks In the setup window,

You can connect your computer to the laser cutter via USB or Ethernet.

For a more stable connection over long distances, you can configure a static IP address on both your PC and the machine.

Run the installation file and select "Install".