Vd-tgm0001.rar Page

: Save small accessories, hair strands, or weapons for last to avoid breakage during handling. 4. Adhesives

: For heavy parts (like a large cape or an outstretched arm), drill a small hole in both pieces and insert a trimmed paperclip or brass wire to act as a structural "skeleton" before gluing. 5. Gap Filling VD-TGM0001.rar

: If the parts were resin printed, ensure they are fully cured and washed. If they are physical resin cast parts, wash them in warm soapy water to remove mold release agents. : Save small accessories, hair strands, or weapons

If there are visible seams between parts, use a small amount of or UV resin . Once dry, sand it flush with the surface for a seamless look. If there are visible seams between parts, use

: Most VD-TGM models use a "peg and hole" system. Test each connection before applying glue.

: Start by connecting the largest central pieces.

: This is the standard for resin kits.